Test Print Method; Producing A Test Print; Hexadecimal Dump - Star TSP2000 Série Mode D'emploi

8-1. Producing a Test Print

To start test print, set the power switch to off, set the paper in place, then set the
power switch to on while holding down the FEED switch. Release the switch
within three seconds.
When a certain amount of printing is performed, the printer will cut the paper and
stop automatically.

8-2. Hexadecimal Dump

This prints data sent from the host in hexadecimal format and in the correspond-
ing ASCII characters. This is useful for debugging applications and for analyzing
scrambled characters.
Starting and stopping Hex Dump printing
While holding down the Feed switch, turn the power on. Hold down the switch
for five seconds; Hex Dump will begin operation when the switch is released.
If the switch is released within three seconds, the Self Test will run.
Stop Hex Dump by turning the power off.

8. Test Print Method

The received data is printed as follows.
Address Hexadecimal data
– 19 –
ASCII data