A-2. Print Specifications; A-3. Auto Cutter Specifications; A-4. Interface; A-5. Power Supply - Star TSP2000 Série Mode D'emploi

A-2. Print Specifications

(1) Print width
(2) Character size
(3) Character structure
(4) Character set

A-3. Auto Cutter Specifications

(1) Partial cut
(2) Cutting frequency
(3) Thickness of paper

A-4. Interface

(1) Interface
(2) Command

A-5. Power Supply

(1) AC Adaptor
(2) Input
(3) Output
(4) Power Consumption
(5) Power Connector
Signal
Pin No.
name
1 +24V
2 SG
3 N.C.
Note 1: This power connector is used to supply the control and mechanical
sections of the printer.
72 mm (576 dots)
Front A: 1.50 × 3.00 mm
Front B (ESC/POS mode only): 1.13 × 3.00 mm
Front A: 12 × 24 dots
Front B (ESC/POS mode only): 9 × 24 dots
ASCII:
Extended graphics: 128 × 8
International:
Cutting with one point left uncut
Max. 30 cuts per minute
Max. 0.08 mm
RS232C serial interface or Two-way parallel inter-
face (IEEE1284)
TM
ESC/POS
UP06021240, switching type
100 to 240V AC, 50/60 Hz
DC 24V±5%, 2.5A MAX
Operating: Approx. 65 VA (at print duty 14%)
Stand-by: Approx. 5 VA
I/O
Function
direction
Drive power IN
Signal GND
– 88 –
96
32
commands or Star commands
1
<Viewed from Connector Surface>
3
2