Removing Remaining Paper - Star TSP2000 Série Mode D'emploi

(5) If the power switch is set to OFF, set it to ON to turn on the printer. Make sure
that the ERROR LED is not lit.
Note: While the ERROR LED is lit, the printer will not accept any commands
such as the print command, so make sure that the printer cover is locked
properly.
(6) Once the printer cover is locked, the paper end will be ejected and the end cut
off automatically.

5-2. Removing Remaining Paper

(1) Pull the lever toward you to open the printer cover.
Note: Make sure that the lever is pulled until it stops at the stopper. If the lever
is not pulled up to the stopper, the printer cover may not open.
(2) Remove the remaining paper.
– 13 –