Vocal Messages - LEGRAND 675 20 Notice D'installation

7 - Dialling device menu
Jolly number
Index book

7.4 - Vocal messages

Vocal messages are sent from the Unit to the set telephone numbers when a particular event
occurs (see above section) e.g. "the burglar alarm system is in alarm", or as an answer to telephone
commands sent by the user (par. 6.6) e.g. "roller shutters up".
This menu allows recording, relistening and storing of the personalizable parts of the vocal
messages. The complete message that the user will hear during a call will consist of pre-recorded
parts and personalized parts, for example, in case of a gas leak, the message will be:
Antitheft System. Attention gas alarm press a number to listen after pressing a number the
user will hear:
Personalized message (address) + the system is ON, attention gas alarm + enter code.
After typing in the correct code, the user can send commands to the Unit. A vocal message will
be returned, e.g. executed.
If a wrong code is typed in for three times in a row, the Unit cuts OFF the communication.
Pre-recorded messages
Personalizzable messages
Antitheft System, warning + type of
alarm (e.g. intrusion)
Antitheft System, warning + type of
alarm (e.g. supply lack)
Antitheft System, warning +
personalized message
When recording the messages, watch the time available, which is set at 8 seconds for the address
and 2 seconds for the other messages.
However, it is possible to listen to the message again and, if the recording is incomplete or
unsatisfactory, make a new one. The pre-existing message will not be cancelled unless the
function Memorize is selected.
The time available to record the message is displayed by a number of asterisks that gradually go
OFF as the seconds go by.
- If there is a power line voltage failure, all messages will remain stored.
- If the battery is dead or not connected, it will not be possible to access this menu.
Set calls Tel. Functions Tel. commands
Pre-recorded
part
Press a
number to
listen
Part to be Pre-recorded
recorded
System status
Message
recorded by...
name and
type of alarm
address of
user
enter code
part
(e.g. ON)
+
+
133