System Configuration - LEGRAND 675 20 Notice D'installation

4 - First activation
At the end of the system learning the request to send the configuration to display devices
(e.g. Keypad connector with display) appears. This will let the devices not only show the alarm-
given signal but also indicate the zone and the sensor which detected it.
send
not send = CLEAR
send
not send =CLEAR
try again = OK
exit conf. =CLEAR
exit conf.=CLEAR
If you modify the system, by adding or removing devices, it is necessary to execute the self-
learning function in order to update the configuration of the system stored by the Unit.
102
Send
configuration?
= OK
Prepare
system
= OK
ATTENTION
Transm. Error
System
configuration
OK
If there are display devices in the system:
Press to enter
On the contrary
Press to cancel
Set up the devices to receive the configuration
as indicated in their installation manuals
Press to enter
Press to cancel
If the page at the side appears make sure that
all the devices are correctly connected to the bus
and ready to receive the configuration
Press to enter
Press to cancel