Loss Of Maintenance Code - LEGRAND 675 20 Notice D'installation

6 - Burglar-alarm menu
Scenarios
Tamptest
Ext. siren fl ash
Maintenance Code

6.9 - Loss of Maintenance Code

This procedure allows the installer to retrieve his code if it has been forgotten or lost.
• Make sure the system is OFF;
• Take the Unit OFF the bracket. This operation will produce an alarm;
• Flip the slide switch ON the back of the Unit in OFF position;
• Press the Reset pushbutton. The Unit switches to "Maintenance";
• It is now possible to read the code by accessing the submenu "Maintenance Code".
126
Zones Devices
- enables or disables the periodic check of the interconnections between
the Unit and devices connected.
Interconnections: if a peripheral device does not communicate with the
Unit due to disturbances, the installer has the possibility to keep this from
producing an alarm by disabling this control.
- this function indicates, through the flashing external siren, if the burglar
alarm is ON (3 flashes) or OFF (one flash).
- the user code and maintenance code coincide in the basic configuration
and let you access all menus. This function lets you distinguish them in
order to access the menus reserved for the installer.
The Maintenance Code must be modified before the user code can be
modified.
The maintenance code does not enable/disable the system.
If the system is enabled it will not be possible to access the menus with
the Maintenance Code.
To escape from the Maintenance menu, it is necessary to press the
is no time-out after 30 seconds.
(the Unit does not automatically return to the initial page if the keypad is not used for
more than 30 seconds).
Date and hour Automations
Event memory
Settings
, key , since there