Adjusting The Armrests; Automatic Power Shutdown; Charging The Batteries - Vermeiren Mercurius 4 LTD Manuel D'utilisation

Masquer les pouces Voir aussi pour Mercurius 4 LTD:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
EN
NL

3.5.5 Adjusting the armrests

CAUTION
 Make sure that the armrests are positioned symmetrically from the seat.
 Always mount the inner tube on a safe distance of 50 mm in the outer tube.
The armrest can be adjusted in height and depth.
Adjusting armrest height
CAUTION
Adjusting armrest width
3.6

Automatic power shutdown

In order to avoid accidental battery rundown, your scooter is equipped with an automatic power
shutdown facility. If the scooter is switched on and remains undisturbed for a period of ten
minutes, it will automatically turn off. Should this occur, simply switch your scooter off and back
on and it will be ready to use again.
3.7

Charging the batteries

WARNING
 Only use the battery charger delivered with the scooter. The use of any other charger may be
dangerous (fire hazard).
 The battery charger is only intended to charge the batteries delivered with the scooter, not to
charge any other batteries.
 Do not adapt any of the delivered parts, like cables, plugs or battery charger. Never open or
change the battery or the connection points.
 Protect the battery and battery charger against flames, high and low temperatures (see chapter
6), moisture, sunshine, severe shocks (for example dropping). Do NOT use the battery if this
has been the case.
 Charge the battery with the battery charger, indoors, in a well-ventilated area, out of children's
reach.
 First read the user instruction of the applied battery charger before charging the scooter's
battery. For more information, contact your specialist dealer or consult our website
http://www.vermeiren.com/
Risk of tipping over
Risk of injury - Do not put your fingers, buckles, clothes, jewelry between
the swing away system of the armpad.
1. Fold the armpad backwards.
2. Loosen the star knob.
3. Grasp the armpad.
4. Move the armpad upwards or downwards until the desired
height (range: 30 mm stepless).
5. Retighten the star knob.
6. Make sure that the armrest is well secured.
1. Loosen the star knob on the back of the scooter.
2. Grasp the inner square tube.
3. Move the tube to adjust the armrest to the desired depth
(range: 120 mm each side stepless).
4. Retighten the star knob.
5. Make sure that the armrest is well secured.
Risk of injuries and damage due to fire
14
Mercurius 4 LTD
2020-10
Using your scooter

Publicité

Table des Matières
loading

Table des Matières