Operator Control; Lcd Display - Vermeiren Mercurius 4 LTD Manuel D'utilisation

EN
NL
 When driving indoors, only use the lowest speed setting.
 Do not turn your scooter "OFF" while driving as this will lead to an emergency stop and
possible risk of accident and injury.
 Keep the braking distance in mind, see also the technical specification in chapter 6. Be aware
that the braking distance depends on speed, surface, weather conditions, slope and weight
of the user.
 Pay attention if the road has holes or gaps that may cause entrapment of the wheels.

3.2.1 Operator control

 Switch the scooter ON by turning the key.
 The battery level indicator (1) will light up and show the current level of your batteries.
 Press the speed control (2, 3, 4) to select the desired driving speed.
o Press button (4) to choose between the high/low speed setting.
o Press button (2) to lower the speed within the chosen setting.
o Press button (3) to raise the speed control.
 To sound the horn, press the horn button (5).
 To switch on the front and back lights, press the light button (7).
 To switch on the emergency flashers, press button (10).
 To switch on the indicator lights, press the desired button (9) (right indicator) or (8) (left
indicator). The buzzer will make a beeping sound when turning the indicators lights on.
2
7
8

3.2.2 LCD display

1
2
3
The time setting is linked to the battery system.Once you change to or connect new batteries, you
must reset the time setting.
The system has a mileage memory for driving distance. You do not have to reset the mileage
display after changing the batteries.
4
1
3
6
5
10
9
4
1. Battery level indicator / LCD display
2. Speed control (slow)
3. Speed control (fast)
4. Speed switch
5. Horn
6. Set: change mode
7. Lights (front and rear)
8. Indicator (left)
9. Indicator (right)
10. Emergency lights
5
6
7
8
8
Mercurius 4 LTD
Using your scooter
1. Temperature display
2. Speed bar
3. Speed display
4. Time display
5. Mileage or distance display
6. Battery indicator
7. High / slow speed mode
display
8. Controller fault code
2020-10