Publicité
•
do not allow children or disabled people to use the remote control or other operating devices;
•
carry out routine maintenance;
•
in the case of a fault, disconnect the power supply and only move the gate if it is possible and safe to do so. Do not touch the gate and
call in an authorised technician.
WARNING:
IT IS ABSOLUTELY FORBIDDEN TO WASH THE AUTOMATION USING WATER JETS OR SIMILAR EQUIPMENT. IT IS
SEVERELY PROHIBITED TO SPRAY WATER ON THE AUTOMATION.
MAINTENANCE
The geared motors in the SPEED 2-8 need very little maintenance. However the gate itself must be in good conditions if they are to work
properly, hence we shall describe briefl y what you need to do to keep your gate effi cient at all times.
ATTENTION: no one, except the person who services the equipment (who must be a specialised technician), should be able to
command the automatism during servicing. Consequently, it is advisable to turn the electricity off at the mains also to avoid possible
electric shocks. If the electricity has to be on for certain checks, check or disable all command devices (remote controls, push button panels,
etc.) except for the device being used by the maintenance person.
Routine maintenance
Each of the following operations must be carried out when necessary and always every 6 months for domestic use (approx. 3000 work
cycles) and every 2 months for intensive use such as blocks of fl ats (always 3000 work cycles).
Gate
- Lubricate the gate's sliding wheels with an oiler.
- Check that the rack is clean and securely fi tted in place.
Automation unit
- check the proper working order of the safety devices (photoelectri cells, pneumatic edge, etc...) accordingto the manufacturer's
instructions.
Extraordinary maintenance or breaks
If there are any complex jobs that need doing on electromechanical parts, it is advisable to remove the relative part so that the repairs can
be carried out in the workshop by parent company technicians or their authorised technicians.
14
Serie SPEED
TAU srl
Publicité
