Pioneer PDP-S29-LR Mode D'emploi page 11

Connecting the Speaker cords
Turn off the power of all connected units before connecting the cords.
Connect the display's EXT SPEAKER R and L
terminals with the speakers' terminals using the
included connection cords.
Mounting the Speakers on the Display ... When Using a Wall Mount Unit
* In some cases it is not possible to tighten the installation pieces' screws
after the display is mounted on the wall. In such cases install using the
procedure described below.
① Mount the installation pieces on the display in the
positions shown on the diagram below using the
included M4 screws.
② Partially fasten the installation pieces for the top side
using the included M6 screws.
RIGHT LEFT
Peel off the protective tape from the back of
the clamper, then mount the clamper in the
desired position and clamp the cords together.
There is polarity
connection cord.
Connect each conductor to the correct terminal.
While holding the button of each speaker
terminal, insert a conductor of the
connection cord.
［M6］
3〜6mm
E-4
with the conductor of each
＋ −
Black
Red
〔M4〕