Comelit 1409 Manuel Technique page 5

3. MODE WITH EXTERNAL AUDIO UNIT
Generic/coded actuator modes can also be used on a system which
includes an audio-only external unit Art. 1622 - 1621.
For operation with "audio only" external unit:
1. set DIP 1 of selector "S1" as illustrated below:
2. set the external unit to video mode as shown in the picture below
In this mode, every time a call is received from the external unit or
when self-ignition takes place, the monitor switches on and displays
the image from the first camera connected to Art. 1409. It will be
possible to cycle through all cameras connected by repeatedly
pressing the programmed button.
4. MODE WITH SWITCHBOARD 1998A
Generic/coded actuator modes can also be used on a system which
includes Video calls from switchboard.
In this mode, every time a video call is made from the switchboard,
the monitor switches on as soon as the handset is lifted (or the audio
button is pressed), and the image displayed will be the one from the
first camera connected to Art. 1409.
At this point, each time a control button is pressed (see generic/
coded actuator modes) or each time the manual contact is closed
:
(available by connecting the INA-GND contact to the OUT-OUT
terminals of the switchboard as per diagram IK/EN/004QC), you will
be able to cycle through all available cameras.
„ To use this function, the remote camera module must be
connected to the outgoing Bus line from terminals LM-LM of the
switchboard, and the switchboard set to "Video mode" before
the call.
5. COMPATIBILITY TABLE FOR ART. 1409 WITH 1256 OR
OTHER 1409 UNITS
Generic actuator mode
Compatibility
with 1256 in generic actuator mode
Compatibility No other 1409 in generic
with Art. 1409
Coded actuator mode
No. 1256 units in coded
No. 1256 units actuator mode with
codes between 220
and 227
1409 only in mode 2 with
actuator mode 8 separate codes
5