Connections - Sharp PN-80TC3 Manuel D'installation

Caution
• Be sure to turn off the main power switch and disconnect the plug from the power outlet before connecting/disconnecting
cables. Also, read the manual of the equipment to be connected.
• Be careful not to confuse the input terminal with the output terminal when connecting cables. Accidentally reversing cables
connected to the input and output terminals may cause malfunctions and the other problems.
1
2
For power outlet
TIPS
• Set the audio input terminal to be used in each input mode in AUDIO SELECT on the SETUP menu. The factory settings are
shown below.
Input mode Audio input terminal (Factory setting)
D-SUB1 Audio1 input terminal
D-SUB2 Audio2 input terminal
DisplayPort DisplayPort input terminal
• To use the touch panel, the touch panel and computer must be connected, and Touch Panel Settings Tool, Touch Pen Utility,
and Pen Software must be installed on the computer from the supplied CD-ROM.
When the Touch Display Downloader is installed, you can check and download the most recent versions of the software
programs.
To install the software, see the manual for each.
• The USB port varies depending on the terminal connected to the computer.
D-sub 1 input terminal/DisplayPort input terminal/HDMI 1 input terminal
D-sub 2 input terminal/HDMI 2 input terminal/HDMI 3 input terminal
(Factory setting. Can be changed in TOUCH INPUT SELECT in the SETUP menu.)
• Download the setup program for the Touch Viewing Software with the Touch Display Downloader.
• The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks
of HDMI Licensing, LLC in the United States and other countries.
• DisplayPort is a registered trademark of Video Electronics Standards Association.
6
E
19
3 4 5 6 7 8

Connections

13
14
15
16
17
18
9 10 11 12
Input mode
HDMI1
HDMI2
HDMI3
1. AC input terminal
2. Power cord (Supplied)
3. External speaker terminals
4. Audio output terminal
5. DisplayPort output terminal
6. Touch pen adapter port
7. USB 1 port (for touch panel)
8. LAN terminal
9. D-sub 1 input terminal
10. DisplayPort input terminal
11. HDMI 1 input terminal
12. Audio 1 input terminal
13. RS-232C input terminal
14. USB 2 port (for touch panel)
15. D-sub 2 input terminal
16. HDMI 2 input terminal
17. HDMI 3 input terminal
18. Audio 2 input terminal
19. USB cable
To use the USB port on the front of
the tray (for USB device) (USB 2.0
compliant), connect the USB cable
to the USB port on the computer.
(The touch panel must be connected
separately.)
Audio input terminal (Factory setting)
HDMI 1 input terminal
HDMI 2 input terminal
HDMI 3 input terminal
USB 1 port
USB 2 port