Supplied Components; Preparing The Remote Control Unit And The Touch Pen - Sharp PN-80TC3 Manuel D'installation

If any components are missing, please contact your dealer.
 Liquid Crystal Display Monitor: 1
 Remote control unit: 1
 Power cord
 Remote control unit battery
(R-6 ("AA" size)): 2
 Cable clamp: 3
 Cable clamp (insertion type): 4
* SHARP Corporation holds authorship rights to the Utility Disk program. Do not reproduce it without permission.
* For environmental protection!
Do not dispose of batteries in household waste. Follow the disposal instructions for your area.

Preparing the Remote Control Unit and the Touch Pen

Installing the batteries
1. Press the cover gently and slide it in the direction of the
arrow.
2. See the instructions in the compartment and put in the
supplied batteries (R-6 ("AA" size) x 2) with their plus (+)
and minus (-) sides oriented correctly.
3. Close the cover.
Connecting the touch pen adapter
To use the touch pen, insert the touch pen adapter into the
touch pen adapter port on the monitor.
Touch pen
adapter port
Touch pen
adaptor

Supplied Components

 CD-ROM (Utility Disk): 1
 CD-ROM (Touch Display Link): 1
 Touch Display Link License: 1
 Setup Manual (this manual): 1
 Touch pen (for capacitive touch panel)
(PN-ZL03): 2
 Touch pen adapter (PN-ZL01): 1
 Pen tip for touch pen
(for capacitive touch panel): 8
 Touch pen battery
(LR-03 ("AAA" size)): 2
 Tray: 1
 Speaker cover: 2
Inserting the battery
2 touch pens are supplied. Insert the batteries in the touch
pens.
1. Remove the battery cap.
2. Open the cover and insert the supplied battery (LR-03
3. Replace the cover and battery cap.
• To use an optional touch pen with the monitor, the touch
Touch pen
adapter screw
(antitheft)
 USB cable: 1
 RS-232C conversion cable (3.5mm mini jack): 1
 Eraser (for capacitive touch panel): 1
 Camera mount: 1
 Camera screw (inch thread): 1
 Touch pen adapter screw (Step screw, M3): 1
 Speaker cover attachment screws (M3)/
Camera mount screws (M3): 6
 Vertical sticker (Logo): 1
 ID labels (for touch pen): 4 x 2
 Cover SHARP logo: 1
Place this sticker onto the SHARP logo to cover
the logo.
("AAA" size) x 1) into the touch pen.
Check the plus (+) and minus (-) markings on the inside
of the touch pen and insert the battery in the correct
orientation.
TIPS
pen must be registered in the touch pen adapter. (pairing)
For details, see the operation manual.
2
1
Battery cap
5
E