Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RULES FOR CONVERTING AND INSTALLING FOR OTHER TYPES OF GAS
Our appliances are tested and regulated for liquid gas (see plate inside).
The conversion or adaptation to another type of gas must be carried out by a specialized technician. The nozzles for the
various types of gas are in a bag supplied with the appliance and marked in hundredths of mm (see the "Technical Data"
table).
SUBSTITUTING THE NOZZLE IN THE MAIN BURNER
•
In order to operate inside the appliance, it is necessary to empty the water container.
•
Remove the front fixing screws from the panel, remove the start up cable from the piezoelectric ignition device.
•
Unscrew the nut and lower the air regulation stirrup.
•
Using a suitable spanner, unscrew the nozzle and substitute it with the right one (see the "Technical Data" table).
•
Put the air regulation stirrup into its original position.
SUBSTITUTING THE NOZZLE IN THE PILOT BURNER
The flame of the pilot burner has fixed air.
The only operation necessary is the substitution of the nozzle according to the type of gas.
It is therefore necessary to unscrew the screws as specified in the previous point; with a suitable spanner unscrew the
fitting and substitute the nozzle with a suitable one. With the right nozzle, the flame must lap the thermocouple.
Important!
After having carried out the conversion to another type of gas, it is necessary to update the data plate, indicating the
type of gas for which the appliance has been converted.
•
The appliance contains the instructions necessary for use.
•
Check the appliances for gas leaks.
•
Examine the flame of the pilot burner; it must lap the thermocouple and be blue, otherwise examine the nozzle of
the pilot burner.
•
Check the lighting and flame of the main burner.
•
We urge the user to follow the instructions when using the appliance.
IT
CH
GB
CHECKING FUNCTIONING
34
IE
Publicité
Chapitres
Table des Matières
