NEFF L 2530 Série Mode D'emploi Et Instructions De Montage page 19

2. Preparing for installation:
The gas built-in facia and fixing plates
are screwed together when supplied
and must be separated before
assembly.
3. Remove protective caps.
4. Position the gas built-in facia from the
front and set it on the two bracket
plates.
5. Screw fasten the gas built-in facia using
the two fixing plates and the three
knurled nuts.
Note:
Firstly position the knurled nuts and
turn only slightly.
Align the gas built-in facia vertically
and horizontally.
Tighten the knurled nuts by hand until
the gas built-in facia is seated all the
way round.
Do not use any tools when
tightening.
6. Make the mains connection and the
electrical connection between the hob
and the gas built-in facia.
Secure the connecting cable between
hob and gas built-in facia using the
retaining clip.
Connect the earth cable of the hob to
the earth screw.
7. Install hob.
It is imperative to follow the assembly
instructions enclosed with the
appliance.
8. Function check.
When properly installed the appliance
must be covered on all sides in such
a way that any contact, even to
functionally insulated parts, is
impossible. The cover should only be
removable using tools.
Assembly Instructions
19