Thermostat Settings - RADSON 51043 Guide D'utilisation

1 Thermostat settings (for the main zone only)
On this submenu you can adjust the actual settings temperature and
humidity level for the main zone (zone managed by the programmer).
With the keys (◄-) or (►+) move the selection cursor in front of the
setting which must be adjusted, then press the (OK) key to start
blinking the value. Now you can adjust the value with (◄-) or (►+).
Once the value adjusted press (OK) to valid your adjustments.
- The day and night
mode (Heating or Cooling).
- The Humidity level is used only in cooling mode to prevent the
house of residual humidity in the air.
If humidity is detected the system will stop the cooling function in the
house and start up the humidity drier.
You could see the activation of this function in the status line of the
main screen.
* The drop and the
level will be blink to
indicate the
humidity level is
reached in the
main room only.
** The drop will be
blink alone only
when humidity is
detected by the
UFH RF MASTER.
Note:
You can reach quickly this menu by pressing the (OK) key during 2
seconds on the main screen.
Thermostat Setti

20.0°C
18.0°C
rH 60%
settings, will be these of the current working
Monday 27 / 04 / 2009
33%
11
11 :15
22.6
°C