Shure PG ALTA Série Guide De L'utilisateur page 4

Using the Quick-Release Lever
This microphone features a quick-release lever to easily
adjust position.
1. Pull the lever open
2. Move the microphone into the desired position
3. Press the lever back towards the microphone to tighten
1
Certifications
This product meets the Essential Requirements of all relevant
European directives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from:
www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: EMEAsupport@shure.de
4
2
3
Note: To adjust the
tension on the lever,
pull it open and use a
flat head screwdriver
to tighten or loosen
the bolt on the
opposite side.
Specifications
Type
Dynamic (moving coil)
Frequency Response
50 to 12,000 Hz
Polar Pattern
Cardioid
Output Impedance
150 Ω
Sensitivity
at 1 kHz, open circuit voltage
-55 dBV/Pa¹ (1.75 mV)
Polarity
Positive pressure on diaphragm produces positive voltage on pin 2
with respect to pin 3
Weight
454 g (16.01oz.)
Connector
Three-pin professional audio (XLR), male
Environmental Conditions
Operating Temperature
Relative Humidity
1 Pa=94 dB SPL
20
0,6 m (2 ft.) from sound source
15
10
5
0
-5
-10
-15
-20
-25
-30
20 100
Typical Frequency Response
Typical Polar Pattern
-20° to 165°F (-29° to 74°C)
0 to 95%
1k 10k
Hz
1000 Hz
20k