Hudora 65596 Instructions De Montage Et Mode D'emploi page 10

INSTRUCTIONS ON ASSEMBLY AND USE
EN
CONGRATULATIONS ON PURCHASING THIS PRODUCT!
Warning! Please read these instructions carefully. The instructions are an inte-
gral component of the product. Therefore, please store them and the packaging
carefully in case questions arise in the future. Please always include these in-
structions when handing on the product to a third party. This product must be
assembled by an adult. This product is designed for private/domestic use only.
This product is not designed for commercial/industrial use. The use of the pro-
duct requires certain capabilities and skills. Always adjust according to the age
of the user and use for the purpose it has been designed for.
TECHNICAL SPECIFICATIONS
Item: Jump In Safety Trampoline 140
Item number: 65596, 65609
Maximum set-up dimensions: 1,40 m x 1,40 m x 1,83 m
Purpose: Trampoline for children with a max. user weight
of 25 kg for jumping in a private area.
WARNINGS! SPECIAL SAFETY INSTRUCTIONS
• Not suitable for children under 36 months due to small swallowable parts.
Choking hazard.
• Max 25 kg.
• Only for indoor use.
• The trampoline shall be assembled by an adult in accordance with the assem-
bly instructions and thereafter checked before the first use.
• Only one user. Collision hazard.
• Always close the net opening before jumping.
• Jump without shoes.
• Do not use the mat when it is wet.
• Empty pockets and hands before jumping.
• Always jump in the middle of the mat.
• Do not eat while jumping.
• Do not exit by a jump.
• Limit the time of continuous usage (make regular stops).
• Do not use in strong wind conditions and secure the trampoline.
• Only for domestic use.
• In certain countries during winter period, the snow load and the very low
temperature can damage the trampoline. It is recommended to remove the
snow and store the mat and the enclosure indoors.
• Please replace the self securing nuts after loosening them as the self securing
structure will be damaged.
• Keep away from fire.
• Follow the measures under „Maintenance and Storage" as well as the in-
structions under „Safe Use". Non-observance of the aforementioned points
can lead to serious hazards for the user.
• Sufficient clearance above the trampoline must be ensured. A minimum of 2
m is recommended. Remove all cables, branches and other potential hazards.
The trampoline must be set up only on a firm and level ground.
• The trampoline requires sufficient horizontal distance from things around it.
Make sure that you set it up away from walls, power cables, fences and pla-
ying areas. Ensure a free space of 2 m around its diameter.
• Do not eat and drink while using the trampoline.
• The net should be replaced every 3 years.
SAFETY INSTRUCTIONS
• Keep young children away while assembling to prevent any risk of strangula-
tion from long cords or of asphyxiation from small parts! For this reason, cut
off cord ends to a maximum of 5 cm after the assembly.
• Position the trampoline on a level surface before using it.
• Use appropriate lighting in dark places.
• Do not place the trampoline on a concrete floor, a hard ground (rocky surface)
or a slippery surface.
• Do not leave any object on the trampoline and remove anything that can hit
the person jumping on it.
• Used rain covers must be kept outside of the reach of children (choking ha-
zard).
• Improper use or misuse of the trampoline is dangerous and can cause a seri-
ous injury!
• The person owning the trampoline and the person supervising the people on
the mat are responsible for making the techniques and warnings mentioned
in the user manual known to all users.
• The trampoline must only be used in the presence of an experienced super-
visor with relevant expertise. Make sure that your children are always within
sight while using the trampoline.
• The trampoline must be mounted and dismounted by climbing up and down.
• Get on and off the trampoline through the inlet in the safety net. Access and
exit the trampoline by thereby climbing up and down respectively. Do not
attempt to enter the trampoline by crawling under the safety net.
• In order to mount the trampoline correctly, hold the frame with your hands and
climb up or roll on to the frame, over the frame padding and on to the mat.
Always make sure that you hold the frame with your hands while climbing up
or down. Do not immediately climb on to the frame padding and do not hold
on to the frame padding. In order to dismount correctly, get to the edge of the
trampoline, hold the frame with your hands and climb down from the mat on
the floor.
• Do not allow pets on the mat to protect it from cuts and damages.
• Do not wear clothing having drawstrings, loops and hooks. Buckles, if any,
should not be hard or have a rough surface.
• Do not use the trampoline under the influence of alcohol or drugs.
• The mat must not come in contact with sharp or pointed objects.
• Ensure that there is no one under the trampoline.
• Only suitable for domestic use!
• Landing on head or neck can cause paralysis or death! Somersaults are not
recommended as they increase the risk of landing on head or neck.
• Not suitable for pregnant women.
• Make sure that the warning messages printed on the trampoline are readable
when the user enters through the safety net entrance.
• Ensure that the hook and loop fasteners are positioned 100% on top of each
other. Otherwise they may not function correctly.
• The trampoline is neither intended nor suitable to be buried into the ground.
• Recommendation for supervisors: Take care that the user frequently takes a
break to avoid exhaustion and ensure full body control.
INSTRUCTIONS ON ASSEMBLY
BEFORE SETUP
Please check that you've received all parts listed above. If you are missing any of
the parts, please contact our customer service. Please use gloves while assem-
bling the product to ensure that you protect your hands from injury.
ASSEMBLY INSTRUCTIONS
Only our enclosed tools are needed to assemble the trampoline. If you are not
using the trampoline, it can be easily disassembled and stored.
Step 1 – Assembly of the frame and feet (Fig. 1)
All parts with the same part number are interchangeable and exhibit no diffe-
rences with regard to a left or right orientation. Only the narrow end of a tube
piece has to be inserted into larger the end of the next tube piece in order to
connect the parts. There are a total of six frame tubes (A) available from which
the frame has to be assembled. After which the 3 feet (B) have to be inserted
into the support. You should ultimately now screw on the lower net rods (E), with
the help of the appropriate screws (J and K) as well as the spacers (H). Make
sure that you have properly aligned the feet tubes. The recess for insertion of the
nut has to face the trampoline centre.
Step 2 – Aligning of the jumping mat (Fig. 2)
Set up the jumping mat with the sewn-on net as shown. The sewing yarn at the
edge of the mat must face in the direction of a rod (E).
Step 3 – Spanning the jumping mat (Fig. 3)
To span the mat, you require the included clamps (M). The following steps work
best when the mat is held slightly under tension.
3.1 To begin with you have to pass the tether strap (I) through the lugs of the
jumping mat. Place the resulting loop over the frame. The stopper of the tether
strap is positioned underneath the mat-lugs.
3.2 Pass the clamp from the top through the loops and beneath the frame, up to
the end of the tether strap.
3.3 Upon pressing the levers of the clamp downwards, the tether strap slips in
the direction of the mat.
3.4 With a final application of the clamp lever, the loop is finally lifted over the
stopper of the tether strap.
3.5 After the first tether strap has been attached, the next tether strap should
be attached to the frame on the opposite side of the first tether strap. After the
first two tether straps have been placed, the next strap should be placed halfway
between. The next strap should be attached to the frame on the opposite side.
Please repeat until all straps are placed. A sequential mounting of the tether
strap, would quickly lead to a one side distribution of the tensile forces and the
assembly would be impaired.
10/24