Declaration Of Conformity - brennenstuhl JARO 13000 Mode D'emploi

Projecteur led
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
JARO 13000
1. Always turn off the power supply before installation
2. Unscrew the junction box
3. Insert the connection cable
braids of the connection cable according to marking N and L
4. Fasten the pressure plate and screw the junction box on
5. Remove the retaining bracket from the spotlight
6. Mark the position of boreholes
holes on the wall. Attach the bracket to the wall with suitable screws
7. Secure the spotlight to the retaining bracket
8. Adjust the desired position of the spotlight and tighten the U-bolts
9. Turn the power supply back on
MAINTENANCE
The LED light does not contain parts that need servicing.
The LED light source in this lamp may only be replaced by the manufacturer or a service
technician commissioned by the manufacturer or a comparably qualified person.
Never open the lamp when the mains supply cable is connected.
CAUTION: Risk of life due to electric shock!
CLEANING
Do not use solvents, caustic cleaning agents or similar products. Only use a dry or slightly
moistened cloth for cleaning.
DISPOSAL
Dispose of electric appliances in an environmentally friendly manner!
Electric appliances must not be disposed of in household waste!
The European Directive 2012/19/EU on Waste Electrical and Electronic Equipment
rules that used electric appliances should be collected separately and recycled in an
environmentally friendly manner.
For possibilities of disposal of the used appliance, please contact your local or municipal
administration.

DECLARATION OF CONFORMITY

The declaration of conformity is stored at the manufacturer's.
Addresses
Hugo Brennenstuhl GmbH & Co KG · Seestraße 1 – 3 · D - 72074 Tübingen
H Brennenstuhl S A S · 4 rue de Bruxelles ∙ F - 67170 Bernolsheim
lectra-t ag · Blegistrasse 13 · CH - 6340 Baar
www.brennenstuhl.com
18P150 LED Strahler Jaro 13000 0499085 190312.indd 7
on the back and loosen the pressure plate
through the inlet pipe of the junction box and connect the
.
for securing the retaining bracket and drill the respective
.
.
Operating Instructions
.
.
.
.
.
.
D
7
12.03.2019 10:39:31

Publicité

Table des Matières
loading

Table des Matières