grandimpianti AS 27 Mode D'emploi page 22

www.groupdynamics-laundry.com
sales@groupdynamics.lv
Programs/cycles and their respective cooling setting can be scrolled using the "UP" and
"DOWN" keys. Move to the desired cycle and press "ENTER". Then choose between "YES"
and "NO" using the "UP" and "DOWN" keys and press "ENTER" to confirm.
Press "MODE" to exit.
3-B-2 Short spinning
Spin: This function allows to acknowledge the standard-selected spinning, reduce it to one-
minute spinning or eliminate it altogether. Select "SPIN" using the "UP" and "DOWN" keys.
Press "ENTER" to confirm.
Programs/cycles and their respective reduced spinning setting (enabled/disabled) can be scrolled
using the "UP" and "DOWN" keys. Move to the desired cycle and press "ENTER". Then again
using the "UP" and "DOWN" keys choose among:
NORMAL
REDUCED
NO SPINNING
Press "ENTER" to confirm.
Normal: standard final spinning is carried out
Reduced: one-minute final spinning. Spinning length is applied to the last spinning speed. The
acceleration ramp is never reduced.
No spinning: final spinning is not carried out.
Press "MODE" to exit.
3-B-3 No prewashing
Prewash: Generally speaking, all programs include prewash. The purpose of this function is
actually to skip prewash, and is especially useful when handling laundry that is not heavily
soiled.
Select "PREWASH" using the "UP" and "DOWN" keys.
Press "ENTER" to confirm.
Programs/cycles and their respective prewash setting can be scrolled using the "UP" and
"DOWN" keys. Move to the desired cycle and press "ENTER". Then choose between "YES"
and "NO" using the "UP" and "DOWN" keys and press "ENTER" to confirm.
Press "MODE" to exit.
3-B-4 Deferred cycle start
Delay START: This function defers machine start to a maximum of 24 hours. As soon as the
scheduled time has elapsed the machine starts automatically. When waiting for the deferred start
the machine reads the countdown. If during the countdown the "START" key is pressed, the
machine immediately starts the cycle that was originally selected.
Select "DELAY START" using the "UP" and "DOWN" keys.
Press "ENTER" to confirm.
The parameter status, i.e. either "DISABLED" or "ENABLED" will appear. Press "ENTER" to
change the selection. Use the "UP" and "DOWN" keys to make your selection in minutes and/or
hours and then press "ENTER" to confirm.
Press "MODE" to exit.
As soon as the "START" key is pushed the countdown starts and the display reads the following
message:
Page 22/36 utilisation d1500 fr-EN.1 par PS le 08/04/2005