Setting Parameters - grandimpianti AS 27 Mode D'emploi

www.groupdynamics-laundry.com
sales@groupdynamics.lv

3 SETTING PARAMETERS

3-A PROGRAMMING PROCEDURE first level
The first level is dedicated to the user, whereas the second is aimed for the expert user,
maintenance technician or laundry manager.
Caution!
The two level is protected by a PASSWORD and is described in the programming manual.
All the programming that the common user can access is explained in the cycle programming
instructions and in the machine parameters section.
3-A-1 Cycle programming
The wash programs or cycles can be summarised as a sequence of actions that the appliance
carries out from machine start to the end of the program.
The various actions are listed in the "STEPS" menu below.
Foreword: the washing machine is delivered with series of steps, i.e. actions, stored in memory.
These enable the execution of the preset standard cycles.
Using the programmer it is possible to change the existing programs or create new ones starting
from pre-set steps. In this case the user does not need to posess specific knowledge on the wash
diagram that best suits the fabrics to be washed.
In other words, it is possible to enable or disable a certain step in a standard program or either
choose existing steps as appropriate and add them one by one. Steps will be carried out in the
order in which they were put in.
The user can thus customise programs according to his/her own sequence of steps. If this should
not be sufficient to suit the specific requirements, it will be necessary to access the "steps menu"
and create customised steps, which can then be included in a program, either existing or new.
The "CYCLES" menu is accessed as follows:
Open the washer door: all programming actions must be performed with the door open. The
programing environment cannot be accessed when the door is closed.
Hold down the " MODE" (and enter pass word) until the "CYCLES" reading appears. Confirm
using "ENTER". The display will view the first among the 30 available CYCLES OR
PROGRAMS. Use the "UP" and "DOWN" keys to scroll the complete list of cycles, which are
associated words denoting their name, like "WHITES" or type like "STRONG". Free, meaning
empty cycles are simply marked "NOT PROGRAMMED".
Once the program to be altered has been chosen, press "ENTER". The display will then read the
following items:
COMMENT
STEPS
TYPE
COPY FROM
COPY TO
The various items are described below.
3-A-1-1 COMMENT
Go to the "COMMENT" field using the "UP" and "DOWN" keys. Confirm the selection by
"ENTER". A text field will be displayed, which is made of 10 characters and can be used to
assign a program name, e.g. "WHITES 90°C". To enter characters, press the "SELECT" key: all
Page 19/36 utilisation d1500 fr-EN.1 par PS le 08/04/2005