SOLIS PRIMAROMA Mode D'emploi page 44

DESCALIN G
s
Prolonged use or hard water can cause limestone deposits to form in and on many
functioning parts of your machine and reduce operating performance – which, in
turn, reduces the quality of the espresso.
This is why Solis recommends regularly (depending on water hardness but at least
once a month) descaling your Primaroma with a mixture of SOLIPOL
water. Please use only SOLIPOL
chine. Damages caused by the use of improper descaling agent are not covered by
warranty.
GB
Proceed as follows:
1. Insert the portafilter (without ground coffee) into the brewing head. Pour a
®
mixture of SOLIPOL special and water in a ratio of 1:1 into the water tank and
fill it to the MAX marking.
2. Connect the power plug to the socket.
3. Press the ON / OFF button so that the red function light illuminates and the ap-
pliance is switched on.
4. Place a large tank under the brewing head resp. the portafilter and an empty
milk jug under the steam wand.
5. The function button should not be pushed in but be in the brewing position
instead. The selector is set to the standby position in the center l.
6. Wait for the green temperature control light to light up permanently. Turn the
selector to the left to the cup position
through.
7. Then return the selector to the standby position in the center l.
8. Now, press the function button inwards to set the appliance to steam function
and wait for the white temperature control light to light up permanently.
9. Then, turn the selector to the right to the steam position
escape from the steam wand into the prepared, empty milk jug (or directly into
the drip tray) for approx. 2 minutes.
10. Then, return the selector to the standby position in the center l. Press the func-
tion button again to set the appliance back to brewing mode.
11. Press the ON / OFF button for at least 3 seconds to switch the appliance off. Let
the descaling solution sit for 15 minutes.
12. Switch the appliance back on after 15 minutes and repeat steps 5 to 11 at least
3 times until the descaling solution is almost used up.
13. When the descaling solution is almost used up, remove the water tank and
carefully rinse it with fresh water to flush out all the descaler residues, then refill
it with fresh tap water.
86
®
special (Art.-No. 703.02) for descaling the ma-
and let approx. 2 cups of water run
and let steam
14. To rinse out the machine as well and to remove all descaler residues, please
repeat steps 5 to 10 until only a small amount of water remains in the water
tank. The soaking time of 15 minutes as mentioned in step 11 does not have
to be kept.
15. Remove the water tank again, empty it and refill it with fresh tap water.
16. Remove the portafilter from the brewing group and rinse it under running water,
®
special and
after that, dry it.
NOTE: Please wipe potential splashes of descaling solution on the appliance casing
away immediately, as the agent might damage the surface.
WARNING: Never submerge power cord, power plug or the appliance itself
in water or any other liquid. During descaling, never remove the water tank
or allow it to empty completely.
GB
87