Wireless Transmission - Monacor TXA-1022CD Mode D'emploi

Masquer les pouces Voir aussi pour TXA-1022CD:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
The IR remote control for the player is sup-
plied with a battery . Prior to initial operation,
remove the protective film from the battery
holder . When pressing a button, always direct
the remote control to the infrared sensor (21) of
the player . There must be no obstacles between
the sensor and the remote control .
If the remote control is not used for a longer
time, remove the battery as a precaution so that
the remote control will not be damaged in case
the battery should leak .
Replacing the battery:
Push the latch of the battery holder to the right
(arrow 1 in the figure below) and remove the
holder (arrow 2) . Remove the old battery and
insert the new battery (3 V button cell, type
CR 2025) into the holder with the positive pole
pointing upwards . Push the holder back into the
remote control .
Batteries must not be placed in the
household waste . Always take them
to a special waste disposal (e . g . collec-
tion container at your retailer) .
To switch the player on /off, use the POWER
button (20) .
Inserting a replay medium:
– Insert a CD with the lettering showing up-
wards into the CD slot (A) until it is retracted
automatically .
– Connect a USB storage medium (USB flash
drive or USB hard disk with separate power
supply) to the USB port
– Insert a memory card (notched corner up-
ward and contacts to the right) into the slot
SD / SDHC (C) until it engages .
SD / SDHC
To remove the card, slightly push it into the
slot until it disengages .
To switch between the replay media, use
the button MODE (23) . When a medium has
been read in, it will be replayed automatically .
If a USB storage medium or a memory card has
been selected and is then removed, the player
automatically switches over to the CD player
mechanism . The same happens when a new
CD is retracted .
Control options and information on the display
indications can be found in chapter 3 .1 .
All rights reserved by MONACOR
may be reproduced in any form or by any means for any commercial use.
8 Specifications
Amplifier power
Rated power: � � � � � � � � � 120 W
Music power: � � � � � � � � � 170 W
Speakers: � � � � � � � � � � � � � 25 cm (10") bass speaker
Frequency range: � � � � � � � � 20 – 20 000 Hz
Input sensitivity: � � � � � � � � 6 mV (MIC 1 / 2),
Level LINE /AUX OUT: � � � � � 1 V
Connections
MIC 1: � � � � � � � � � � � � � � combined
MIC 2: � � � � � � � � � � � � � � 6�3 mm jack, bal�
LINE IN / OUT: � � � � � � � � � � RCA jacks
AUX IN / OUT: � � � � � � � � � � � 3�5 mm jacks
Tone control: � � � � � � � � � � ±10 dB / 100 Hz (BASS)
Ambient temperature: � � � � 0 – 40 °C
Power supply:
Mains voltage: � � � � � � � � 230 V / 50 Hz
Power consumption: � � 170 VA
Battery operation: � � � � � � internal rechargeable
Operating time: � � � � � � 4 – 6 hours approx�
Dimensions (W × H × D): � 360 × 580 × 320 mm
Weight: � � � � � � � � � � � � � � 19�2 kg

8.1 Wireless transmission

Range: � � � � � � � � � � � � � � � approx� 30 m
Transmitting power of
the transmitter module: � � � ≤ 10 mW (EIRP)
(B) .
Channel
01
02
03
04
05
06
07
08
Note concerning multichannel operation:
The number of channels to be used in parallel de-
pends on the conditions at the place of application
(e . g . on interference due to other wireless systems
or high-frequency sources such as fluorescent lamps) .
In ideal conditions, up to four channels can be oper-
ated at the same time without mutual interference .
Two examples of a suitable channel selection for four
wireless transmission paths:
Example 1:
channel 01 – channel 03 – channel 06 – channel 12
Example 2:
channel 06 – channel 09 – channel 15 – channel 16
Subject to technical modification .
®
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual
and 2�5 cm (1") tweeter
300 mV (LINE /AUX IN)
XLR jack / 6�3 mm jack, bal�
±10 dB /10 kHz (TREBLE)
lead gel batteries
(2 × 12 V / 4�5 Ah)
Radio frequencies
Frequency
Channel
Frequency
863 .1 MHz
09
863 .2 MHz
864 .1 MHz
10
864 .2 MHz
863 .6 MHz
11
863 .7 MHz
864 .6 MHz
12
864 .7 MHz
863 .3 MHz
13
863 .4 MHz
864 .3 MHz
14
864 .4 MHz
863 .8 MHz
15
863 .9 MHz
864 .8 MHz
16
864 .9 MHz
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

17.4610

Table des Matières