3M Bair Hugger 360 Mode D'emploi page 5

CAUTION: To reduce the risks associated with environmental contamination:
• Follow applicable regulations when disposing of this device or any of
its electronic components.
NOTICE
1. The temperature monitoring system meets medical electronic interference
requirements. If radio frequency interference with other equipment should
occur, connect the unit to a different power source.
2. Protection against electrostatic discharge (ESD) is important when
working with the temperature monitoring system. Always be mindful of
the immediate work area and any potentially hazardous ESD situations
that could impact temperature monitoring system performance.
3. To avoid temperature monitoring system damage that may impact
performance:
• Do not store the control unit and system components in a wet or
damp place.
• Do not spray cleaning solutions onto the control unit or into the
sensor cable connector.
• Do not immerse the control unit or system components in any
liquid, use a dripping wet cloth for cleaning, or subject them to any
sterilization process.
• Do not use solvents such as acetone or thinner to clean the control
unit; avoid abrasive cleaners.
• Cleaning should be performed in accordance with hospital practices
for cleaning OR equipment. After every use wipe the device surfaces,
cords and cables. Avoid getting liquid into electronic ports. Use a
damp soft cloth and a hospital approved mild detergent, germicidal
disposable wipes, disinfecting towelettes, or antimicrobial spray. The
following active ingredients are acceptable for cleaning:
• Oxidizers (e.g. 10% Bleach)
• Quaternary Ammonium Compounds (e.g. 3M™ Quat Disinfectant
Cleaner)
• Phenolics (e.g. 3M™ Phenolic Disinfectant Cleaner)
• Alcohols (e.g. 70% Isopropyl Alcohol)
4. The sensor is not made with natural rubber latex.
5. To the full extent permitted by law, the manufacturer and/or importer
declines all responsibility for injury resulting from the unit being used in
conjunction with unapproved system components.
Warranties/3M Liability
Model 360 Product Warranty
WARRANTY INFORMATION
3M warrants only that the Bair Hugger sensor (the "Product") will meet
3M's applicable physical product specification at the time of shipment to
the customer. The terms of this Warranty do not affect or prejudice the
statutory rights of a purchaser acquiring the Product otherwise than in
the normal course of a business.
DISCLAIMER
3M DOES NOT OFFER ANY OTHER WARRANTY AND DOES
NOT WARRANT THE PERFORMANCE, SAFETY OR SUCH OTHER
3