Brandt BD8712NWX Manuel D'instruction page 24

5 - PROBLEMS
1 -
Here are a few points to check:
Problems:
Water drips onto the floor
The light is not working
"Alarm stop" function activated
and flashing blue semi-circle
If your screen displays a code starting with the letter "E", call your After-Sales Department.
INTERVENTIONS / EXPORT CONSUMER RELATIONS
1 - 1 - 1 -
Any repairs to your appliance must be made by a qualified professional accredited to work on the brand. In order
to facilitate the processing of your request, please have available your appliance's commercial reference when
you call; you may find this reference on the label located near the crisper.
Original parts:
When work is required, request exclusively original certified spare parts.
For information:
or contact your seller directly.
EN
(continued)
The water pan (located at the rear bottom of the cabinet) may not be pro-
perly levelled, or the draining spout (located under the compressor) may not
be properly positioned to direct water into the pan. The water draining spout
may be blocked.
Check the pan and gutter at the back of the appliance.
- The LED light may be damaged. Refer to the chapter
"Cleaning and Care" to replace the LED light.
- The control system switches the light off if the door remains open too long.
Close the door and open again to switch the light back on.
The temperature inside is too high.
- Check that the door opens correctly
- Set the temperature.
If the fault persists, call after-sales service.
Causes / Remedies:
24