Sage The Big Squeeze SJS700 Guide Rapide page 4

Assembly
BEFORE FIRST USE
Before using your Juicer for the first time, remove
any packaging material and promotional labels.
Ensure the power is in the OFF position, the juicer
is switched off at the power outlet and the power
cord is unplugged.
Wash bowl and juicing tools in warm soapy water
with a soft cloth. Rinse and dry thoroughly.
When first using your appliance, you may notice
an odour coming from the motor. This is normal
and will dissipate with use.
TOP SET ASSEMBLY
Align the dots on each part and assemble
in the order shown. Once assembled, turn the
drum lid clockwise to close.
TOP-SET AND BODY ASSEMBLY
Place the drum lid on the juicing bowl. Align the
red dot on the drum lid with the ALIGN mark
on the body and turn to the LOCK position.
6
ASSEMBLY
1. Firmly insert the compression silicone into
the slot below the pulp spout. The Juicer
may leak if not assembled properly.
2. Assemble the strainer into the rotation
wiper then place this assembly in to the
juicing bowl ensuring the red dot on the
strainer is aligned with the red dot on the
juicing bowl.
3. Place the juicing screw into the strainer. Turn
and press down on it until it clicks into place.
The juicing screw needs to be locked in place
in order to close the drum lid.
4. Place the drum lid on to the juicing bowl
aligning the dot on the drum lid with the
red dot on the juicing bowl.
TIP
For easy assembly hold the drum lid by grabbing
the feeding tube and turn clockwise as shown
in the illustration.
5. Align the red dot on the drum lid with the
ALIGN mark on the body and turn to the
CLOSE position.
EN
7