Using Your Steam Mop - shark S4601 Série Manuel Du Propriétaire

Using Your Steam Mop

IMPORTANT: Make sure you do not use the Steam Mop without attaching a Pocket Pad and adding water
to the Water Tank first. When you are using the Steam Mop for the first time, it might take longer than
the normal 30 seconds to start steaming.
IMPORTANT: Do not use on unsealed wood or unglazed ceramic floors. On surfaces that have been treated
with wax and on some no-wax floors, the sheen may be removed by the heat and steam action. Test an
isolated area of the surface to be cleaned before proceeding. Check the use and care instructions from the
floor manufacturer.
fig. 6
NOTE: To prolong the life of your Steam Mop, we
recommend using distilled water.
NOTE: Sweep or vacuum your floors prior to
cleaning with your Steam Mop.
1
Pull and twist the Quick-Release Cord Holder to
unwrap the power cord completely (fig. 6). Plug
into an electrical outlet.
2
The unit will be in Standby Mode as soon as it is
plugged in. The Standby Mode can be identified by a
blinking light around the Steam Control Button (fig. 7).
3
Press the Steam Control Button to select the LO, MED,
or HI Steam Setting (fig. 7). Press once for the LO
setting, twice for MED, three times for HI, and four
times to return to Standby Mode. Once in Standby
Mode, a light will blink around the Steam Control
Button, but all other Steam Setting Lights will be off.
4
Clean your floors with a forward and backward motion.
5
When you come to a tough, dried-on floor stain, use
the Scrub Blast Mode to clean it away.
7 1-800-798-7398
LO
MED
fig. 7
HI
6
To engage the Scrub Blast Mode, slide the Engage
Scrubber/Release Head Button all the way down until you
hear a click (fig. 8). The Stain Scrubber will automatically
pop into position. Lift the Mop Body off the Mop Head and
place the Stain Scrubber on the floor to start scrubbing.
CAUTION: While in Scrub Blast Mode, do not
leave the Steam Mop stationary.
CAUTION: Do not Scrub any one area for an
extended period of time.
7
To go back to mopping, re-dock the Mop Body onto the
Mop Head. The Stain Scrubber will automatically retract.
8
When you are done mopping, press the Steam
Control Button until you return to Standby Mode.
9
When the Water Tank is empty, the Steam Mop will stop
producing steam. You can refill the Water Tank at any
time as long as the Steam Mop is unplugged. Follow the
Water Tank filling instructions on page 6.
NOTE: Please wait 2 to 3 minutes for the Steam
Mop to cool off before switching the Mop Head or
the Pocket Pad. Never leave the Steam Mop with a
damp/wet Pocket Pad on any floor.
fig. 8