Ibiza Light LAS160P Manuel De L'utilisateur page 2

Safety Recommendations
•
Before any installation and repair, please do cut off the power
supply.
•
For safety reasons, install the unit firmly to avoid injury and
damage.
•
Do not cover the unit.
•
The product should be installed by professional technician.
•
Do not touch the unit with wet hands or pull the power wire
forcefully.
•
The system should be kept dry .Please don't use the system in the
condition of rain, wet or dust. For indoor use only.
•
Do not turn on or off the system frequently, and avoid keeping it
working for a long time.
•
Fixed Installation prevents the system from strong shaking or
striking.
•
Prevent objects to get into the system, or there will be malfunction.
•
Leave at least 1m distance between the unit and other objects.
•
Please don't connect the power supply or turn on the system
before installation.
•
Before switching on power, please make sure the power wire is in
good condition.
•
Where the MAINS plug or an appliance coupler is used as the
disconnect device, the disconnect device shall remain readily
operable.
•
Please warm-up for 15 minutes before turning on the system. Turn
off the system for 25 minutes after running continuously for three
hours. Ensure the system is able to cool down in a suitable
environment and has steady output power.
•
When transport the system again, please use the original package
to avoid shaking.
This sign indicates collecting in sort about electronics and electrical
equipment.
Statement
The user should comply with the instructions and warnings above. Any
damage, which is caused by incorrect operation or not following the
manual, is not covered by the warranty.
Installation guide
Be sure that there are no inflammable or explosive objects within 1.5m
distance.
Before installation, please make sure the power voltage matches the
©Copyright LOTRONIC 2012 LAS160P
system rated voltage.
Be sure that the fan and exhaust is not blocked.
Features
Remote-controlled red & green firefly laser supplied with a stand to create
a sky of twinkling stars in your room. It contains 20 gobos that generate a
large variety of patterns such as dynamic liquid sky, animated moving stars,
cloud formation, skulls and many more...
•
Fully adjustable motion speed
•
Auto-run, music or remote controlled
•
2x music modes
•
20x gobos
•
Supplied incl. remote control
Specifications
Input voltage: 12Vdc
Rated power: 7W
Laser power: 50mW green / 100mW red
Laser wave length: 532nm green; 650nm red
Laser color: Green & red
Control mode: Stand alone, 2 x music controlled modes, remote controlled
Dimensions: 140 x 120 x 90mm
Weight: 0,600kg
Front and Rear panel of the unit
1. Signal LED
2. Power LED
3. Receipt signal
4. 12Vdc power input
5. Power ON/OFF
6. Mode (music1, music2, auto)
7. Mic sensitivity
2