IKA KS 4000 i control Mode D'emploi page 26

Use only cleansing agents which have been approved by IKA to clean IKA devic-
es: water containing tenside / isopropyl alcohol.
- Wear the proper protective gloves during cleaning of the devices.
- Electrical devices may not be placed in the cleansing agent for the purpose of
cleaning.
- Before using another than the recommended method for cleaning or decon-
tamination, the user must ascertain with the manufacturer that this method
does not destroy the instrument.
Collecting tray with drain hose (for picture see below)
(applies to KS4000 i control and KS4000 ic control)
In the event of glass breakage, leaking liquid is collected by the collecting tray
below the shaking table and guided to the drain hose via a drain at the rear.
1. Remove drain hose from bracket
2. Place drain hose in laboratory drain
Cleaning of the collecting tray:
- four countersunk head screw at the
top side of the shaking table loosen
- shaking table upward remove.
Cleaning the Plexiglas cover:
- Do not dry wipe.
- Do not use abrasive materials.
Clean dusty surfaces with warm water, detergent and a soft cloth.
For disinfecting, only use products prescribed by the manufacturer specially for
use on Plexiglas.
Note: Isopropanol (2-propanol) can be used for cleaning or disinfection (bacteria
and viruses).
26