SilverCrest SV 125 C3 Mode D'emploi page 15

CAUTION – PROPERTY DAMAGE!
If the control lamp w does not turn off after a maximum of
10 seconds during the sealing process, the appliance is
defective!
► Remove the plug from the mains power socket immediately. Do not attempt
to repair the appliance yourself. Contact the Customer Service department.
6) Open the appliance lid 1 by pressing the lid release 8 and flipping the lid 1
upwards. Remove the bag. This is now sealed at one end.
NOTE
► Ensure that the weld seam is properly closed. A correct weld seam should
be a smooth, straight stripe without any creases.
7) Fill the bag. You must leave at least 6 cm of the bag free up to the edge to
be welded.
CAUTION – PROPERTY DAMAGE!
► Fill the bag so that no food scraps or liquids can leak out during welding
and get into the appliance.
8) If you do not want to vacuum the bag, you can now weld the other, open side.
NOTE
► Wait a few seconds to allow the appliance to cool down before sealing
the next bag.
During this cool-down phase, you cannot start the "seal" function.
■ 12 │ GB │ IE SV 125 C3