Pkm 9031 Mode D'emploi page 35

doors and/or windows
 mounting rail is not firmly fixed
 screws are not firmly tightened
If the hood does not work properly and/or you can hear increased operating noise,
 Incorrect dimension of the air duct.
 Obstruction in the air duct.
 The diameter of the air duct from hood to wall-box inclusive should be 120
mm; otherwise the capacity of the motor may be decreased.
 If you have installed a fly screen on the wall-box, the air vent may be
obstructed. Check by removing the fly screen.
 If the cover panel of the wall box is equipped with firm and slanted slats, the air
vent may be obstructed. Check by removing the cover panel.
 Install a cover panel with moveable slats, which do not obstruct the air vent.
 Check condition and cleanliness of the filters.
 Check if the air which is extracted by the hood is replaced to avoid negative
pressure.
 When you run your appliance in recirculating mode, check if the carbon filter
has been replaced on time (min. every 3-6 months).
If the appliance has a malfunction not noted on the schedule or if you have
checked all items on the schedule but the problem still exists, please contact
6
Model
Material
Installation width
Push buttons
Recirculation/extraction mode
Grease filter
Lights amount/W/kind
Connected load
Voltage
Carbon filter
5
Extraction mode: installation with ventilation stack or air duct outwards only, wall
penetration = 120 mm, drilling about
Appliance is unstable.
check the schedule below:
the shop you purchased the appliance at.
TECHNICAL DATA
5
 fix mounting rail properly
 tighten the screws
9031
Cooker hood
stainless steel

1*aluminium.
2
220~240V/50Hz
ca. 130 mm.
35
60.00 cm
5

2*28 Halogen
176 W
2*CO2
6