Pkm 9031 Mode D'emploi page 30

11. Drill two holes (diameter 8 mm/use the stencil) into the wall. Now screw the
screws and the dowels into the holes. The distance screw head ↔ wall must be
10 mm.
WARNING! Do not damage the wiring in the wall while drilling.
12. Position the inner chimney on the 2 screws and adjust it. Tighten the screws.
 Insert the grease filters and connect the appliance to the mains
correct position of the hood from front and side perspective. Otherwise the
appliance will not work properly.
3
If the socket is covered by the chimney, you must plug in the appliance at an
earlier point in time.
30
3
. Check the