Product Specifications; Unpacking - Delta 31-484 Manuel D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Oscillation rate

Oscillation stroke

Spindle Speed

Motor

Table Size

Spindle Tilt

Spindle Size Range

Dust Chute

Base Dimensions

NET Weight

The machine is heavy, be careful when removing it from the shipping container! Failure to comply

may cause serious injury and/or damage to the tool and/or property!

This step requires two adults. The machine is heavy, be careful when removing it from the shipping

container! Failure to comply may cause serious injury and/or damage to the machine and/or

property!

Your DELTA

Heavy Duty Oscillating Floor Spindle Sander comes packed in a single container. Use a safety strap to

avoid tip-over when lifting machine. Check shipping carton and machine for damage before unpacking.

1. Carefully cut the banding straps and remove them from the container.

2. Cut along the tape line at the top of the container.

3. Remove any loose parts accessible from the top of the container and set aside.

4. Cut vertically along each of the four sides of the container to fully expose the machine.

5. Remove any loose parts or hardware and set aside.

6. With the help of a second adult, carefully lift the machine off the pallet and onto a level floor surface.

7. Compare all parts to the list below and check that all parts are present and in good condition.

DESCRIPTION (QUANTITY)

• Floor spindle sander (1)

• Motor cover (1)

• Steel spindles and sanding

sleeves (4) (Diameter - 1/4",

3/8", 1/2", 5/8")

• Rubber spindles and sanding

sleeves (6) (Diameter - 3/4", 1",

1-1/2", 2", 3", 4")

• Oblong table inserts (3 (small,

medium, large)

Report any missing or damaged parts to your distributor or dealer. Prior to tool assembly and use, read this manual

thoroughly to familiarize yourself with proper assembly, maintenance and safety procedures.

Remove any protective materials and coatings from all of the parts and the sander. The protective coatings can be

removed by spraying WD-40 on them and wiping it off with a soft cloth. This may need redone several times before

all of the protective coatings are removed completely.

If any parts are missing, do not attempt to plug in the power cord and turn "ON" the machine. The

machine should only be turned "ON" after all the parts have been obtained and installed correctly.