Functional Description; Product Specifications; Unpacking - Delta 31-140 Manuel D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

The DELTA

12" Disc Sander is designed for sanding or polishing flat or beveled surfaces on wood and plastic materials.

Speed:

Disc Diameter:

Table Tilt:

Height:

Width:

Shipping Weight:

Motor:

Table Size:

Dust Collection Outlet:

Miter Gauge Groove:

Length:

Weight:

The machine is heavy, be careful when removing it from the shipping container! Failure to comply may

cause serious injury and/or damage to the sander and/or property!

Your DELTA

12" Disc Sander comes packed in a single container. Use a safety strap to avoid tip-over when lifting

machine. Check shipping carton and machine for damage before unpacking.

Open the shipping container. Carefully remove packaging materials, parts and machine from shipping carton. Always

check for and remove protective shipping materials around motors and moving parts. Lay out all parts on a clean work

surface and check that all parts are present and in good condition:

• 12" disc sander (1)

• Dust collection hose with 2 ¼" port

adaptor (1)

• Brake lever assembly (1)

Compare the items to inventory figures; verify that all items are accounted for before discarding the shipping box. Report

any missing or damaged parts to your distributor or dealer. Prior to tool assembly and use, read this manual thoroughly

to familiarize yourself with proper assembly, maintenance and safety procedures.

Remove any protective materials and coatings from all of the parts and the disc sander. The protective coatings can be

removed by spraying WD-40 on them and wiping it off with a soft cloth. This may need redone several times before all of

the protective coatings are removed completely

If any parts are missing, do not attempt to plug in the power cord and turn "ON" the machine. The

machine should only be turned "ON" after all the parts have been obtained and installed correctly.