Operation - Delta 31-484 Manuel D'utilisation

Failure to read and understand the instructions, warnings and safety guidelines provided in this
manual may lead to serious injury and / or damage to machine or the work piece.
Be sure the sanding spindle is securely installed in the machine.
Make sure the spindle tilt lock is secured and that the spindle is locked in place at the desired angle
or tilt.
Make sure the machine is installed on a flat, sturdy and stable surface able to support the weight of
the machine and the work piece to be sanded.
See Figure 10.
1. Select and install the desired sanding spindle with
the corresponding table insert (see page 10).
2. Ensure the spindle is at the correct sanding angle
(page 13) and that the spindle position is locked
in place.
3. To start the machine, lift the red the safety paddle
(A) and push the green "START" button. Wait for the
spindle to reach full speed before sanding.
4. Hold the work piece firmly and work from a stable
standing position. When the spindle is fully vertical
(90°), you may sand from any part of the table.
When the spindle is tilted make sure the work piece
is positioned on the front half of the table.
5. To achieve the best finish results and to ensure
maximum sanding sleeve life, slowly move the work
piece back and forth across the entire surface of
the sanding spindle
6. To stop the machine, push the red "Stop" button
and wait for the spindle to come to a complete
stop.

OPERATION

Using the Safety Paddle: Your DELTA
Oscillating Floor Spindle Sander is equipped with an
emergency stop safety paddle, enabling you to easily
shut off the machine. To use the Safety Paddle simple
depress the paddle.
12
®
Heavy Duty
FIGURE 10