Maintenance Of The Appliance - Maxspect Gyre 300 Série Mode D'emploi

Maintenance of the Appliance

EN
Your Gyre flow Pump is designed to operate optimally with little attention after initial setup.
However, due to the harsh conditions of a saltwater aquarium and resulting buildup of algae
and other organic matter, it is advisable to clean the pump to ensure the longevity of appliance.
Maxspect recommends doing a cleaning every 6 months or as necessary. This can be
accomplished by opening the impeller housing and gently brushing the impeller and inside of
impeller housing with a soft brush under running water. If there is calcium buildup, it may be
necessary to soak these parts in a mild acid solution such as vinegar. DO NOT use strong acids,
because these may damage the components. After cleaning, reassemble the appliance.
10A
10. Flow Cage
Note: Please note that the impellers and flow cages must be installed to the correct side when
reassembling the gyre after cleaning.
16
11A
A
12
A
B
A
B
11. Impller
Maintenance
11B
B
13
Push Hard
Rotor
12. 13.
10B
Stator