System Setup - Maxspect Gyre 300 Série Mode D'emploi

System Setup

System Setup features a set of functions which allows you to perform maintenance on the
appliance. To enter the System Setup page, first disconnect line A's PSU from the controller
unit, then press and hold the control dial and reconnect the PSU. Keep on holding the
control dial until the system setup page is shown on OLED monitor.
Firmware – Upgrade or downgrade system's firmware.
Reset – Reset user setting to default factory setting.
Test Mode – This function should only be conducted by the users when told by authorized
dealer or customer representative to perform certain test on the appliance.
Exit – Reboot the system to the normal operating status.
Operating Instructions
1. Switch between functions.
2.
Apply the function.
EN
11