Maxspect Gyre 300 Série Mode D'emploi page 7

Operation – Controller Unit
1. Operation – Always follow the operation instructions set forth in this manual when using this
controller unit.
2. Heat – The controller unit should be situated away from heat sources such as radiators, and DO
NOT expose to excessive heat such as sunshine, fire or the like.
3. Moisture – To reduce the risk of fire or electric shock, DO NOT expose the controller unit to rain,
moisture, dripping or splashing.
4. Water Damage – DO NOT immerse in water. If the controller unit falls into the water, DO NOT
reaches for it! First unplug it and then retrieve it. If electrical components of the appliance get
wet, unplug the appliance immediately.
Operation – Gyre Pump
1. Placement – The Gyre pump creates high levels of flow within your aquarium. Please place the
Gyre in an area where corals are not too close to the output flow of the pump.
2. Stall – In the event of a motor stall, the Gyre pump may have stopped for a few possible reasons.
You should first check that there is not something blocking the rotors from spinning.
3. Overheating – The Gyre pump is designed to run underwater. DO NOT run the Gyre pump when
it is not submerged in water. Doing so will cause the Gyre pump module to overheat and could
damage the pump component.
4. Cleaning – Please follow the instruction in this manual to clean the Gyre regularly.
5. Power Outage – During power outage, if a battery backup accessory is added to the Gyre pump,
the pump will automatically switch to Battery Backup mode during a power outage. The pumps
will run at the minimum speed to maximize their run time during this critical period.
Precautions
5
EN