Technical Data - Marmitek AWM2 Guide Utilisateur

when the range of your remotes is not sufficient. The TM13 is using
so called collision detection to prevent signals to be disturbed when
more than one TM13 is transmitting. TM13's will wait for a quite
power line before transmitting their data. To prevent your Marmitek
X-10 System to become slow or to prevent dimming from becoming
less smooth, make sure that the TM13 units are placed as far away
from each other as possible.
Can i use more switches to control the AWM2?
Yes, you can connect more switches to the first switch. However, they
all need to be normal switches (on-off) or all Momentary switches.
do you still have questions?
Please check out www.marmitek.com for more information.

TeChNiCAl dATA

Power:
Electricity consumption
Switching power:
Signal transmission:
X-10 transmission:
Signal sensitivity:
Signal / interference proportion: 1,35 : 1
X-10 Key codes:
Switch use:
Connection range:
Environment temperature:
dimensions:
14
230V ±10%, 50 Hz
< 30 mA capacitive
3600W 230V with temperature
and mounting restrictions.
2300W/230V 500W ind cap
> 5Vpp in 5 Ohm at 120 kHz
± 1kHz
1 pulse burst on 0˚ and 180˚
25mVpp ... 6 Vpp at 120 kHz
± 4kHz
All units Off, All Lights On,
On, Off, Status Request.
normal switches (make/break)
or Momentary switches
Up to 2,5 mm
-10°C to +35°C (operation)
-20°C to +70°C (storage)
46x46x16mm.
2
© MARMiTeK