Freqently Asked Questions - Marmitek AWM2 Guide Utilisateur

When you wish to program the module with the help of a remote
control in combination with an IRRF7243, you need to follow a
slightly different procedure (for instance: setting up UnitCode 2 with
an 8in1 Multimedia remote control):
• push the "house" on the remote control
• push button [2]
• give 2 x an [on] command
• close off with button [2]
An AWM2 cannot send ALL LIGHTS ON or ALL UNITS OFF signals for
the second address itself. It can only receive this signal and based on
this signal, adjust its internal status.

FReQeNTlY AsKed QUesTiONs

What is the reason for modules to switch on/off spontaneously?
It is possible that a Marmitek X-10 System is installed at one of your
neighbours using the same House Code. To solve this problem try to
change the House Code of your system, or have Fd10 Phase Coupler/
Filter installed at your incoming mains.
My modules will not respond to my controller.
Make sure that the House Code on all Modules and Controllers are
set to the same House Code (A .. P).
My modules will not react to my remote / sensor.
When you use a remote or sensor, you should have at least one
TM13 Transceiver or Marmitek X-10 Security Console installed in
your house. These components will translate the radio signals to the
Marmitek X-10 signal on the power line. Using several remotes and
sensors, you only need one central transceiver.
Am i able to increase the range of my remotes by using more
Transceivers?
Yes, you can use more than one TM13 Transceiver in your home
AWM2™ 13