Marmitek AWM2 Guide Utilisateur page 11

Activate or exit the setup mode.
Programming the X-10 address and the various options
The chart below shows the various possibilities to program the
MicroModule AWM2
defaults
Address A1
doesn't respond to
"All Lights On"
doesn't respond to
"All Units Off"
For programming the Marmitek X-10 address and options you will be
able to use any Marmitek X-10 controller or remote control. For the
following explanation we used a Marmitek 8-in-1 remote control to
AWM2™
P prog.
N
Programmable
Address A2 to P16
Responds to "All
Lights On"
Responds to "All
Units Off"
l
Command
2x Address
2x "All lights on"
2x "All Units Off"
Figure 5
light blinks
2x
6x
8x
11