Freqently Asked Questions - Marmitek TM13 Guide Utilisateur

detection' system. This prevents problems
from occurring when several TM13 modules
are used and it allows expansion of the RF
range by using several TM13 modules that
are set to one and the same HouseCode.
The module responds to the following
Marmitek X-10 commands: 'ON', 'OFF' and the
Marmitek X-10 group command 'All Units Off'.
FREQENTLY ASKED
QUESTIONS
What is the reason for modules to switch
on/off spontaneously?
It is possible that a Marmitek X-10 System is
installed at one of your neighbours using the
same House Code. To solve this problem try to
change the House Code of your system, or
have FD10 Phase Coupler/Filter installed at
your incoming mains.
My modules will not respond to my
controller.
Make sure that the House Code on all
Modules and Controllers are set to the same
House Code (A .. P).
Am I able to increase the range of my
remotes by using more Transceivers?
Yes, you can use more than one TM13
Transceiver in your home when the range of
your remotes is not sufficient. The TM13 is
using so called collision detection to prevent
signals to be disturbed when more than one
TM13 is transmitting. TM13's will wait for a
quite power line before transmitting their data.
To prevent your Marmitek X-10 System to
become slow or to prevent dimming from
becoming less smooth, make sure that the
TM13 units are placed as far away from each
other as possible.
Do you still have questions?
Please check out www.marmitek.com
for more information.
TM13 TRANCEIVER MODULE 7