RZ_prima 5+.qxp_Text_EN_prima 5 PLUS 20.12.18 15:17 Seite 14
7
Shutting down
7.1 Emptying & Cleaning >> Figures
WARNING
safety instructions in this manual. Observe applicable laws and the specifications of the
agent manufacturers when disposing of residual quantities.
Initially vent the standing container fully by pulling on the piston-type pressure gauge with the
Now unscrew the pump carefully, at first only a few turns of the thread in a counter-clockwise
built-in safety valve "l" and completely releasing the air.
direction so that any residual compressed air in the container can escape. Only now unscrew and
Do NOT pour the residual quantity into the sink, but pour it through the filling hole into a suit-
remove the pump completely.
able canister.
7.2 Maintenance >>
Observe the national regulations concerning occupational safety which apply to the place of
operation as well as the applicable national regulations for operations.
Only use original GLORIA spare parts for repairs. (see GLORIA spare parts shop https://shop.glo-
riagarten.de).
Repairs must only be carried out by a GLORIA service point.
Regularly coat the seals with GLORIA silicone grease.
Further accessories can be found at www.gloriagarten.de
7.3 Storage >>
CAUTION
reach of children.
Empty and clean the device as in Chapter 7.1.
8
Problems with the device
Fault
Device is leaking at the
screw connection
Spray pattern of
nozzle not OK
Pump does not build
up any pressure
9
Disposal
The emptied and unusable device must be recycled at a collection point, separated according to the materials.
Dispose of packaging materials that are no longer required according to the locally applicable regulations.
10
EU Declaration of Conformity
EU Declaration of Conformity for a module as defined by Article 4, section 3 of the Directive on pres-
sure equipment 2014/68/EU // GLORIA Haus- und Gartengeräte GmbH; Därmannsbusch 7; D-58456 Witten
confirms that the pressurised components of the pressure sprayer prima 5 Plus comply with Directive
2014/68/EU, article 4, paragraph 3.
Witten, 01.12.2018
Danger to health due to escaping spraying agents! Pay attention to the
25
27
Figures
–
28
24
Figures
/
You must therefore store the device and the spraying agents out of the
Cause
Hose loose
Nozzle partially blocked
Filter in quick closure valve
contaminated
O-ring on piston is
worn
Ludger Strunk (Head of Development and Design)
–
24
19
Remedy
Tighten coupling nut and carry
out pressure test with water
Clean filter or nozzle
Replace O-ring
14