Filtration Group EWH 16 Traduction Du Mode D'emploi Original page 15

Fig. 3: Fastening the straps
 Pull the cross belt (3) over the filter housing so that it is
above the centre of gravity but below the handle area. It
must surround the housing loosely.
 Tighten the two straps (2) so that the retaining ring (5) is
pressed against the bottom of the filter housing and
clamps the hexagon.
Risk of injury!
 Make sure the filter housing is held securely in the
retaining ring when you unscrew it.
Fig. 4: Unscrewing the filter housing
 Unscrew the filter housing.
If necessary, use an open-ended spanner to overcome
the initial release torque.
Translation of the original instructions EWH 16, Filtration Group GmbH, 11.09.18, Mat. No. 72462210, Version 00
WARNING!
Fig. 5: Unscrewing the filter element
 Lower the filter housing into the element change aid.
 Unscrew the filter element and push it into the
unscrewed filter housing.
 The filter housing is held by the element change aid.
Fig. 6: Tilting the filter housing
 Tilt the filter housing towards you together with the
element.
Page 5