Glass Door; Installation Area - Avintage DV265MPN1 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
SOLID DOOR 
Your Climadiff wine cellar is equipped with a solid door, so there's no problem. Your wines will remain
protected from light.
GLASS DOOR 
Nothing to worry about either ! it was treated to filter up to 70 % of ultra violet rays !
HOW TO INSTALL YOUR WINE CELLAR 
INSTALLATION AREA 
Be sure to install it in a suitable spot : far away from any heat source, protected from sunshine, not
exposed to low temperatures. This way you will obtain the best operating conditions for the lowest energy
consumption.
Also make sure that the surface area where the cabinet will be installed is flat and resistant (weight of the
device plus its load ; a 75 cl wine bottle generally weighs 1.3 kg).
Do not place it in the open air and be careful to maintain a minimum space of 200 mm between the top of
the cabinet and the ceiling located above it.
Note : the defrosting water recovery tank located at the back of the cabinet near the compressor could
overflow under extreme ambient conditions.
For  this  reason,  we  recommend  choosing  the  appropriate  kind  of  wall  and  floor  surfaces  in  the 
device's  installation  area  so  that  humidity  or  the  possible  formation  of  water  do  not  cause  any 
damage. 
CONNECTION TO THE ELECTRICAL POWER NETWORK  
Be sure to read and understand the safety instructions indicated at the beginning of this guide. 
If the wine cabinet was tilted very much during its transport or placement, it is important to leave the wine
cellar in the vertical position for 24 hours before connecting it so that the lubricating oil can descend and
accumulate in the compressor.
Otherwise, the cooling system could completely break down.
34 
 

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dv315mgn3Dv315apn6-2Dv265apn5Dv315agn4-2Dv265mgn2-2

Table des Matières