Overview Image; Using The Tool - HellermannTyton MST6 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17

5 Overview image

In figure
you will find an overview image of the application tool.
A
1 Hanging loop for safety cord
2 Adjustment dial for setting the tension force
3 Tension indicator
4 Trigger
5 Insertion slot
6 Blade holder

6 Using the tool

CAUTION
There is a risk of injury when pulling the trigger and tightening the tie, or when
using unsuitable ties.
f Always wear safety glasses during use.
f When pulling the trigger, make sure that no limbs are between the trigger
and handle.
f When working above head level, attach a safety cord to the hanging loop at
the bottom of the handle.
f Only use HellermannTyton MST-S series metal ties.
f If necessary, attach a safety cord to the hanging loop
f Set the desired tension force (see section „Setting the tension force").
f Tighten the tie by hand. Make sure that the marking TCA J
facing up. MST-S series ties delivered after November 2013 have a red
mark
(Figure
1
f Insert the tie into the insertion slot as shown in Figure
f Make sure that the head of the metal tie
correctly within the insertion slot
f Figure
shows the correct position of the head. If the upper part of the
F1
head is not flush with the surface of the insertion slot, the position is not
correct (Figure
F2
f Keep pulling the trigger
Operating instruction • MST6 • 12-2014 • 031-93244
) printed on the surface.
C
1
).
(Figure
4
A
Overview image
1
D
(Figure
) is positioned
2
E
(Figure
).
E
) until the tension is released.
(Figure
).
A
(Figure
) is
2
C
.
6

Publicité

Table des Matières
loading

Table des Matières