Beurer FT 65 Mode D'emploi page 11

Ear Temperature Measurement
1. Press and hold the Power Button
Following a successful self test, the thermometer will beep twice, indicating it is ready
for use. Remove the Sensor Cover by gently pushing it up (1) and then pulling it off
(2).
2. Make sure the sensor tip and ear canal are clean. Since the ear canal is slightly
curved, you will need to pull the outer ear slightly up and backwards as shown before
measurement. This enables the sensor tip to be pointed directly at the eardrum for a
more accurate measurement.
3. Insert the sensor tip carefully; press and hold the Power/Ear Button for one second,
then release. The thermometer will beep when the measurement concludes and will
display the ear temperature.
4. If the measured value is below 38 °C/100.4 °F, the green Normal Temperature Range
LED will illuminate for about three seconds. If the measured value is equal to or higher
than 38 °C/100.4 °F, the red High Temperature Indicator LED will illuminate.
Forehead Temperature Measurement
1. Press the Power Button
of the temples on the person to be measured.
2. Press and hold the Forehead Button
person's forehead to the opposite temple, then release.
3. The thermometer will beep twice and display the measurement.
4. If the measured value is below 38 °C/100.4 °F, the green Normal Temperature Range LED will illuminate for about three
seconds. If the measured value is equal to or higher than 38 °C/100.4 °F, the red High Temperature Indicator LED will
illuminate.
for one second to switch the thermometer on.
to switch the thermometer on. With the Sensor Cover in place, position the sensor against one
. While holding the Forehead Button down, move the thermometer across the
Stirn
11
2 1