Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Introduction
MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
we hope your new tool brings you much enjoyment and suc-
cess.
NOTE:
According to the applicable product liability laws, the manu-
facturer of the device does not assume liability for damages
to the product or damages caused by the product that occurs
due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service techni-
cians,
• Installation and replacement of non-original spare parts,
• Application other than specified,
• A breakdown of the electrical system that occurs due to the
non-compliance of the electric regulations and VDE regula-
tions 0100, DIN 57113 / VDE0113.
We recommend:
Read through the complete text in the operating instructions be-
fore installing and commissioning the device.
The operating instructions are intended to help the user to be-
come familiar with the machine and take advantage of its ap-
plication possibilities in accordance with the recommendations.
The operating instructions contain important information on
how to operate the machine safely, professionally and econom-
ically, how to avoid danger, costly repairs, reduce downtimes
and how to increase reliability and service life of the machine.
In addition to the safety regulations in the operating instruc-
tions, you have to meet the applicable regulations that apply
for the operation of the machine in your country.
Keep the operating instructions package with the machine at
all times and store it in a plastic cover to protect it from dirt and
moisture. Read the instruction manual each time before operat-
ing the machine and carefully follow its information.
The machine can only be operated by persons who were in-
structed concerning the operation of the machine and who are
informed about the associated dangers. The minimum age re-
quirement must be complied with.
In addition to the safety instructions contained in this operating
manual and the specific regulations of your country, the techni-
cal rules generally accepted for the operation of machines of
the same type must be observed.
We accept no liability for damage or accidents which arise
due to non-observance of these instructions and the safety in-
formation.
3. Device description
1.
Base plate
2.
Pillar
3.
Drilling table
4.
Machine head
5.
Drill chuck
6.
Grips
7.
Drill chuck protection
8.
Depth stop
9.
Motor
10. On-Off switch
11. Belt protective hood
12. Counternuts for belt tension
13. Laser module
13.1 Laser on/off switch
13.2 Battery compartment cover
14. Vice
A
Hexagonal screw
B
4 mm Allen key
C
Vice fastening screws
D
Drill chuck key
E
Table locking
F
Allen screws
G
Nut fastening, depth stop
H
Philips screw, chuck guard
I
Hole housing, depth stop
J
Nut, depth stop
K
Pointer, depth stop
L
Groove
M
Spring cap
N
Inner nut
O
Outer nut
P
Hub
S
Table locking
T
Laser set screw
U
Laser countersunk screw
V
Belt guard screw
W
Laser locknut
4. Scope of delivery
• Base plate
• Pillar
• Drilling table
• Machine head
• Drill chuck
• Drill chuck key
• Drill chuck protection
• Grips
• Depth stop
• 4 mm Allen key
• Accessory bag
• Laser module
• Operating manual
GB
17
Publicité
Chapitres
Table des Matières
Dépannage
