Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Remote Blower Preparation
CBE-1000 / PBN-1000A: WIRING DIAGRAM
Remote Blower
Wiring Box
(hood)
NOTE: For instructions on installing remote blowers, please refer to the CBE-1000 or PBN-1000A
manuals included in the blower packaging and on our website: www.zephyronline.com
16
White (common)
Black (high)
Junction Box
Blue (med)
(Remote Blower)
Red (low)
Green (ground)
Tornado II & Tornado III Use, Care, and Installation Guide
1. Place 10" round adapter on top of
Power Pack and secure it with (4)
M4x8 screws. Connect 10" round
ductwork to 10" round adapter.
2. Install threaded end of remote
blower wiring through external
blower wiring knock out locked
in junction box on top of power
pack.
3. Place cap over threaded end of
remote blower wiring and secure
by turning clockwise. Connect 6
pin male connector from blower
wiring to 6 pin female connector
in the power pack.
4. Secure green ground wire from
remote blower wiring to ground
screw located inside the power
pack.
P R O
TO R N A D O I I &
TO R N A D O I I I
I N S E R T
Publicité
Chapitres
Table des Matières
