Lumilight Led - Zephyr Tornado II AK8200BS Guide D'utilisation, D'entretien Et D'installation

Maintenance
1. Place filter into top groove of the power pack as shown
and pull towards front of power pack using handles.
2. Pivot back of filter upwards so it is angled in the power
pack.
3. Push filter into channel on back of power pack to lock
into place.

LumiLight LED

In the unlikely event that your LumiLight LED fails, please
contact Zephyr to order replacement parts.
See the list of parts and accessories page for part numbers
and contact information.
LED Removal (FIG. G):
1. Remove baffle filters.
2. Remove the side panels.
3. Disconnect LED light quick connector.
4. Push in the two side clips on the ends of the LED light.
5. Push LED light through the light panel opening.
22 Tornado II & Tornado III Use, Care, and Installation Guide
P R O
TO R N A D O I I &
TO R N A D O I I I
I N S E R T
1
3
2
FIG. F
Push the clip
FIG. G